Pure White Wheel Light Installation Guide
To ensure warranty coverage, it’s essential that you follow these instructions carefully. Wheel lights not installed as directed below may not qualify for warranty coverage.
Begin by positioning your vehicle on a secure, level surface, and safely jack up the vehicle to remove the wheels. Next, carefully remove the brakes and rotor to access the dust shield area. Position the wheel light ring, ensuring it is evenly spaced on the dust shield. Remember, each set includes two directional rings per side for optimal lighting.
Using each bracket’s pre-drilled holes, securely bolt the ring to the dust shield. Ensure that the top of the ring, where the wire and plug emerge, is aligned at the top, closest to the brake line. Proper positioning is essential to maintain warranty eligibility.
Carefully run the wires along your vehicle's brake lines, ensuring there is enough slack to accommodate full steering and suspension movement. Providing sufficient slack helps prevent stress on the solder points, which can otherwise lead to damage.
Run the wires from each wheel to the front of the vehicle, ideally using four separate leads to ensure each wheel light receives consistent power without amperage drop. Once the wires reach the engine bay, connect them to one of our wiring harnesses or to your own preferred switch setup.
Congratulations! With your wheel lights securely bolted and wired, you're ready to light up the road and turn heads wherever you go. If you have any questions or need further assistance, don’t hesitate to reach out at sales@southernlumen.com.